Topcolor WB ESD
The Topcolor WB ESD system is used
- For the renovation of floors already used in conductive two-component epoxy resins*. It will be applied first followed by Topfinish® WB ESD.
- Finishing coating of epoxy resin systems. In the case where your floor is not conductive, the installation of copper strips and the use of the Neoprim Conduct in primary are mandatory before the application of Topcolor® WB ESD / Topfinish® WB ESD system.
* Conductive : allows to reach a resistance <10 ^ 6 Ω of the surface at point connectable to the ground, according to the method of standard EN61340-4-1.
Characteristics
- High mechanical and chemical resistance
- Good resistance to scratching and abrasion
- Aesthetics : perception of flatness defects considerably reduced thanks to the matte / satin / slightly dappled finish
- Waterproof and easily washable : excellent inertness to the usual diluted acids and bases, oils and greases, gasoline and solvents in accidental contact
- Non-yellowing at the U.V
- Conductive* when applied to an already-driving system
* Conductive : allows to reach a resistance <10 ^ 6 Ω of the surface at point connectable to the ground, according to the method of standard EN61340-4-1.
Supports :
- Application on healthy, dry, soil-free and non-adherent supports
- On old resin : mechanically or chemically check the conductivity level
Average consumption : 150 to 180 g/sqm/layer - Packaging : Pre-dosed kit of 5 kg or 4 kg base + 1 kg hardener
VOC Emissions * : A+
* Information on the level of emissions of volatile substances into indoor air, with a risk of inhalation toxicity, on a class scale from A + (very low emissions) to C (high emissions)
Uses
Floor treatment of industrial buildings such as those of the electronics industries :
- In the manufacture, assembly or storage of electronic components
- Clean rooms
- Computer rooms
- Explosive environments
- Interior Exterior ; floors and walls

In the same range
